|
|
General Information about your
Dynojet
Quick Shifter
|
Dynojet Quick Shifter
(Linear)
 |
Dynojet Quick Shifter
(Tension)  |
Shift
Rods
|
Winners are made in
milli-seconds! Dynojet's Quick Shifter helps you maintain a winning
edge by allowing you to up-shift without engaging your clutch or
rolling off your throttle. It works via a very brief
termination of fuel and or ignition, and thereby unloads the
transmission long enough to allow for a gear change. The length of
that termination period is adjustable as is the minimum RPM setting
for the Quick Shifter to engage.
The Quick Shifter functions in connection
with the Power Commander and is fully programmable through the Power
Commander.
No wiring modifications are required; OEM
style connectors are supplied
Note: Some bikes require a Dynojet Ignition
Module for the Quick Shifter to function
properly.
When ordering either
the Shift Rod Pressure/Tension Sensor or the Linear Travel Sensor,
you must make sure to order the correct one for the direction of
movement during the upshift (push or pull).
If using the
shift rod pressure/tension sensor, press on the shift lever in the
direction of an upshift and watch to see if the shift rod is
“pushing” or “pulling” on the clevis on the shift shaft.
This will determine which type is needed. If using the
linear travel sensor move the shift lever in the direction of an
upshift. If this movement is “down” then a “pull type” sensor is
required.
If this movement is “up” then a “push type” sensor
is required.
Includes instructions with helpful pictures
|
Because it is essential to order the
correct version of the Quick Shifter (Pressure/Tension Sensor
vs Linear Travel Sensor, Push vs Pull versions) ,
applicable shift rods, and in some cases an accompanying
Ignition Module, please call us with your bike information and
we will assist you in choosing the correct components.
Call us toll-free at 1-877-271-3966 or 615-874-1005 or
e-mail Konrad@TNTPerformanceDyno.com
| |
General Information about your
Dynojet Ignition Module
The Dynojet Ignition Module
can be added to select Power Commander III USB's and is
connected to the PCIII USB via a built in expansion port link.
It is connected to the ignition coils at either an
intermediate harness or directly to the coil connectors. No
cutting or spicing is required. The Dynojet Ignition Module
uses direct coil driver technology and allows a high degree of
timing adjustment. Not only can the user advance or retard the
ignition curve based on a cobmination of throttle position
and RPM, but now each cylinder can be tuned individually.
In addition, it features "Rev X-tend". The rev limit of the
engine can now be increased without the need to make any
modifications ot the bikes'
ECU.
|
Click
your Motorcycle Brand below to find your Ignition
Module
|
| |
More Performance Parts for your
Motorcycle |
|
|
|
| |
More Performance Parts for your
Motorcycle |
|
|
|
| |
More Performance Parts for your
Motorcycle |
|
|
|
| |
More Performance Parts for your
Motorcycle |
|
|
|
|
